UL 144:2002 pdf download LP-Gas Regulators
Scope1
1.1 These requirements cover pressure regulators for use with LP-Gas equipment
1.2 Regulators covered by these requirements are intended for use in non-refrigerated systems inaccordance with the following standards:
a) Liquefied Petroleum Gas Code,(National Fire Codes, Vol. 2) NFPA 58;
b) National Fuel Gas Code ( IAS/AG.A. Z223.1), NFPA 54;
c)Outdoor Cooking Gas Appliances, IAS/A.GA. Z21.58; and
d) Standard on Recreational Vehicles (RVIAA119.2) (National Fire Codes, Vol. 7), NFPA 501C
1.3 These requirements do not cover:
a) Compressed gas regulators;
b) Gas appliance pressure regulators;
c)Regulators for use in chemical, petroleum, or utility power plants; pipeline or marineterminals; or related storage facilities at such plants or terminals;
d) Combination gas control valves for gas appliances;
e) Regulators for use in oxygen-fuel, gas-welding, and cutting operations; and
f) Regulators for use in engine fuel (automotive and/or marine) applications.
The requirements for (a) -(e) are covered in the Standard for Compressed Gas Regulators, UL 252, andin the Standard for Gas Appliance Pressure Regulators, IAS/A.GA. Z21.18, and in the Standard forCombination Gas Controls for Gas Appliances, IAS/A.G.A. Z21.78, respectively.
1.4 The assigning of flow ratings to regulators is not within the scope of these requirements, andobservations of flow values are required to ascertain stability characteristics within the manufacturer’srated capacity. These requirements include tests to verify outlet pressure stability characteristics within themanufacturer’s rated capacity. The manufacturer is to submit this data prior to the investigation of thedevice. See the Flow Test, Section 22, regarding the outlet pressure instability definition.
1.5 A product that contains features, characteristics, components, materials, or systems new or differentfrom those covered by the requirements in this standard, and that involves a risk of fire or of electric shockor injury to persons shall be evaluated using appropriate additional component and end-productrequirements to maintain the level of safety as originally anticipated by the intent of this standard. Aproduct whose features, characteristics, components, materials, or systems conflict with specificrequirements or provisions of this standard does not comply with this standard. Revision of requirementsshall be proposed and adopted in conformance with the methods employed for development, revision, andimplementation of this standard.
1.5 revised June 14, 2000
2 General
2.1 Units of measurement
2.1 . I Values stated without parentheses are the requirement. Values in parentheses are explanatory or approximate information.
2.1 .1 revised June 1 4, 2000
2.2 Components
2.2.1 Except as indicated in 2.2.2, a component of a product covered by this standard shall comply with the requirements for that component.
2.2.2 A component is not required to comply with a specific requirement that:
a) Involves a feature or characteristic not required in the application of the component in the product covered by this standard, or
b) Is superseded by a requirement in this standard.
2.2.2 revised June 1 4. 2000
UL 144:2002 pdf download
PS:Thank you for your support!