SAE J156-2000 pdf download FUSIBLE LINKS
2.2 Related Publications—The following publications are provided for information purposes only and are not a required part of this document.
2.2.1 SAE P UBLICATIONS —Available from SAE, 400 Commonwealth Drive, Warrendale, PA 1 5096-0001 .
SAE J1 1 27—Low Tension Battery Cable
SAE J1 292—Automobile, Truck, Truck-Tractor, Trailer, and Motor Coach Wiring
2.2.2 ASTM P UBLICATIONS —Available from ASTM, 1 00 Barr Harbor Drive, West Conshohocken, PA 1 9428-2959.
ASTM B 1 —Standard Specification for Hard-Drawn Copper Wire
ASTM B 3—Standard Specification for Soft or Annealed Copper Wire
ASTM B 8—Concentric-Lay-Stranded Copper Conductors, Hard, Medium-Hard, or Soft
ASTM B 33—Standard Specification for Tinned Soft or Annealed Copper Wire
ASTM B 1 74—Standard Specification for Bunch-Stranded Copper Conductors for Electrical Conductors
ASTM B 263—Method for Determination of Cross-Sectional Area of Standard Conductors
ASTM B 298—Standard Specification for Silver-Coated Soft or Annealed Copper Wire
ASTM B 355—Standard Specification for Nickel-Coated Soft or Annealed Copper Wire
ASTM B 452—Standard Specification for Copper-Clad Steel Wire for Electronic Application
ASTM B 787—1 9 Wire Combination Unilay-Stranded Copper Conductors for Subsequent Insulation
ASTM D 41 2—Standard Test Methods for Vulcanized Rubber and Thermoplastic Rubbers and
Thermoplastic Elastomers—Tension
ASTM D 573—Standard Test Method for Rubber—Deterioration in an Air Oven
ASTM E 1 45—Standard Specification for Gravity—Convection and Forced—Ventilation Ovens
ASTM F 1 251 —Standard Terminology Relating to Polymeric Biomaterials in Medical and Surgical Device
3. Definitions
3.1 Coated Wire—Wire comprised of a given metal covered with a relatively thin application of a different metal.
(See ASTM B 354.)
3.2 Fusible Link (Fuse Link)—A section of low tension cable designed to open the circuit when subjected to an extreme current overload. Its purpose is to minimize wiring system damage when such an overload occurs.
3.3 Low Voltage—Usually considered to be ≤60 V DC (25 V AC).
3.4 Short Circuit—An accidental electrical connection between a feed circuit and a return circuit resulting in an extreme current overload.
4. General Requirements—The cable should meet the applicable requirements of SAE J1 1 28, J1 654, or J1 678. Cables other than those defined in SAE J1 1 28 or J1 678 may be used if they meet the functional requirements described in 5.1 and 5.2.
4.1 Conductor—When bare or coated copper conductor is used, the conductor shall meet the requirements of SAE J1 1 28 or J1 678. When conductors other than copper or coated copper are used, the conductors must meet the functional requirements described in Section 5.
4.2 Insulation—Regardless of the type of insulating material used, the fusible link shall meet the performance requirements of SAE J1 1 28, Type TWP for dielectric (withstand voltage), cold bend, flame, fluid compatibility, pinch, and abrasion. When the wire size of the fusible link does not match one found in SAE J1 1 28 or J1 678, the next larger size shall be used.
SAE J156-2000 pdf download
PS:Thank you for your support!
