SAE AS 40401-2000 pdf download Solenoid, Electrical, General Specification For
1 . SCOPE:
1 .1 Scope:
This specification covers the general requirements for electrical solenoids used to actuate various devices through the conversion of electrical signals into mechanical motion. These solenoids are of the axial stroke type and the rotary stroke type.
1.2 Classification:
Solenoids are classified as follows:
2. APPLICABLE DOCUMENTS:
2.1 Government documents:
2.1 .1 Specifications, standards, and handbooks: The following specifications, standards, and handbooks form a part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are those listed in the issue of the Department of Defense Index of Specifications and Standards (DODISS) and supplement thereto.
SPECIFICATIONS
FEDERAL
Q-C-320 – Chromium Plating (Electrodeposited).
QQ-N-290 – Nickel Plating (Electrodeposited).
QQ-S-365 – Silver Plating, Electrodeposited, General Requirements for
2.1.1 (Continued):
STANDARDS
MILITARY
MIL-STD-202 -Test Methods for Electronic and Electrical Component Parts.MIL-STD-1285 – Marking of Electrical and Electronic Parts
(Unless otherwise indicated, copies of federal and military specifications, standards, andhandbooks are available from the Defense Printing Service Detachment Office, Building 4D(Customer Service), 700 Robbins Avenue, Philadelphia, PA 19111-5094.)
2.2Non-Government publications:
The following document forms a part of this document to the extent specified herein. lf the documentis DoD adopted, the issue is that listed in the issue of the DODISS cited in the solicitation.
AMERICAN NATIONAL STANDARDS INSTITUTE(ANSI)
ANSI/NCSL 2540-1 Calibration Laboratories and Measuring and Testing Equipment – GeneralRequirements.
(Application for copies should be addressed to American National Standards lnstitute (ANSl), 11West 42nd Street, New York, NY 10036.
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)ASTM B633 – Zinc on lron and Steel, Electrodeposited Coatings of
(Application for copies should be addressed to American Society for Testing and Materials (ASTM)1916 Race Street, Philadelphia,PA 19103.)
INTERNATIONAL ORGANIZATION FOR STANDARDS (ISO)ISO 10012-1 – Quality Assurance Requirements for Measuring Equipment – Part 1: MetrologicaConfirmation System for Measuring Equipment.
Application for copies should be addressed to American National Standards institute (ANSI), 11West 42nd Street, New York,NY 10036.
Non-Government standards and other publications are normally available from the organizationsthat prepare or distribute the documents. These documents also may be available in or throughlibraries or other informational services.)
SAE AS 40401-2000 pdf download
PS:Thank you for your support!
