SAE AS 39029-49-2000 pdf download CONTACTS, ELECTRICAL CONNECTOR, SOCKET, CRIMP REMOVABLE (FOR MIL-C-22992 CLASS L CONNECTORS)
REQUIREMENTS:
Dimensions, design characteristics, and configuration: See figure 1 and tables I and II.
Tools: See table III.
Probe damage: Probe damage shall be performed in accordance with MIL-STD-1 344, method 2006.2, type 2 fixturing (insert typeholding device) using Mil-C-22992, class L connectors.
Vibration: In accordance with method 2005 of MIL-STD-1 344, test condition III. The following detail and exceptions shall apply.
a. Normal locking means only, no safety wire shall be used.
b. The cable or wire bundle shall be clamped to nonvibrating points at least 8 inches from the rear of the connectors. The clamping length may be selected or changed to avoid resonance of the cable or wire.
c. The system ground contacts of class L grounding connectors shall not be wired into the series monitoring circuit.
Shock: MIL-C-39029/49 contacts shall be tested in accordance with the drop test (class L) and high impact shock test as specified in MIL-C-22992, using a MIL-C-22992 qualified connector that has been approved for listing on the applicable qualified products list.
Mating contact: MIL-C-39029/48.
Material: Copper alloy CDA1 91 or equivalent.
Finish: Silver plate .0002 inch thick minimum in accordance with QQ-S-365. Use underplate of .00005 inch minimum nickel in accordance with QQ-N-290.
Concentricity: .004 TIR(RFS), machined surfaces 63 V unless otherwise specified.
Contacts may be soldered or crimped.
Qualification: Shall include the crimping of these contacts utilizing MS3448 bushings to accommodate smaller wire sizes.
QPL evaluating activity: Defense Electronics Supply Center (DESC-E), Dayton, Ohio 45444.
International interest: NEPR 57, class L only.
Military part number: See table V.
SAE AS 39029-49-2000 pdf download
PS:Thank you for your support!
