SAE AS 22759-7-2000 pdf download WIRE, ELECTRIC, FLUOROPOLYMER-INSULATED, ABRASION RESISTANT EXTRUDED PTFE, MEDIUM WEIGHT, SILVER-COATED CONDUCTOR, 600 VOLT
TEMPERATURE RATING: 200°C (392°F) max conductor temperature
VOLTAGE RATING: 600 volts (rms) at sea level
SPARK TEST OF PRIMARY INSULATION: Not required
IMPULSE DIELECTRIC TEST: 8.0 kilovolts (peak), 1 00% test
INSULATION RESISTANCE: 50,000 megohms for 1 000 ft (min)
WRAP TEST:
“Wrap back” test required; no cracking
Oven temperature; 31 3 ±2°C (595.4 ±3.6°F)
BLOCKING: 260 ±2°C (500 ±3.6°F)
SHRINKAGE: 0.1 25 inch max at 31 3 ±2°C (595.4 ±3,6°F)
WICKING (PROCEDURE I): 1 .0% (max) weight increase
LOW TEMPERATURE (COLD BEND):
Bend temperature: -65 ±2°C (-85 ±3.6°F)
Dielectric test, 3000 volts (rms), 60Hz
THERMAL SHOCK:
Oven temperature, 200 ±2°C (392 ±3.6°F)
Max change in measurement
Sizes 24 through 1 2: 0.060 inch
Sizes 1 0 through 8: 0.1 00 inch
Sizes 6 through 4: 0.1 25 inch
FLAMMABILITY: Post-flame dielectric test not required
LIFE CYCLE:
Oven temperature 31 3 ±2°C (595.4 ±3.6°F)
Dielectric test, 2500 volts (rms), 60Hz
DIELECTRIC TEST AFTER IMMERSION: 3000 volts (rms), 60 Hz
HUMIDITY RESISTANCE: 50,000 megohms for 1 000 ft, min insulation resistance after humidity exposure
SURFACE RESISTANCE: 500 megohm-inches (min), initial and final readings.
SMOKE: 31 3°C (595.4°F)
COLOR: In accordance with MIL-STD-1 04, Class 1 ; white preferred.
COLOR STRIPING OR BANDING DURABILITY: 250 cycles (500 strokes) (min), 500 grams weight
IDENTIFICATION DURABILITY: 1 25 cycles (250 strokes) (min), 500 grams weight
WIRE LENGTH REQUIREMENTS: Schedule A
SUPERSESSION DATA: The wire of this specification sheet, by part number, replaces and supersedes the wire of MS1 8000(ASG) (canceled) in accordance with Table III.

Share on Facebook

Post on X

Follow us

Save