SAE AS 22759-11-2000 pdf download WIRE, ELECTRICAL, FLUOROPOLYMER-INSULATED, EXTRUDED TFE, SILVER-COATED COPPER CONDUCTOR, 600 VOLT
TEMPERATURE RATING: 200°C (392°F) max conductor temperature
VOLTAGE RATING: 600 volts (rms) at sea level
SPARK TEST OF PRIMARY INSULATION: Not required
IMPULSE DIELECTRIC TEST: 1 00% test; 8.0 kilovolts (peak) for sizes 1 8 and smaller, 6.5 kilovolts (peak) for sizes 1 6 and
larger
INSULATION RESISTANCE: 50,000 megohms for 1 000 ft (min)
WRAP TEST:
“Wrap back” test required, no cracking
Oven temperature; 31 3 ±2°C (595.4 ±3.6°F)
BLOCKING: 260 ±2°C (500 ±3.6°F)
SHRINKAGE: 0.03 inch max at 290 ±2°C (554 ±3,6°F)
WICKING: No requirement
LOW TEMPERATURE (COLD BEND):
Bend temperature: -65 ±2°C (-85 ±3.6°F)
Dielectric test, 3000 volts (rms), 60 Hz
THERMAL SHOCK:
Oven temperature, 200 ±2°C (392 ±3.6°F)
Max change in measurement, 0.06 inch
FLAMMABILITY: Post-flame dielectric test not required
LIFE CYCLE:
Oven temperature 275 ±2°C (527 ±3.6°F)
Dielectric test, 3000 volts (rms), 60 Hz
DIELECTRIC TEST AFTER IMMERSION: 3000 volts (rms), 60 Hz
ACID RESISTANCE: Dielectric test, 3000 volts (rms), 60 Hz
CONDUCTOR STRAND ADHESION REQUIREMENTS: Shall be in accordance with 3.6.1 1 of MIL-W-22759.
ABRASION RESISTANCE AFTER IMMERSION: No requirement
HUMIDITY RESISTANCE: No requirement
SURFACE RESISTANCE: 500 megohm-inches (min), initial and final readings.
SMOKE: 290°C (554°F)
COLOR: In accordance with MIL-STD-1 04, Class 1 ; white preferred
COLOR STRIPING OR BANDING DURABILITY: 250 cycles (500 strokes) (min), 500 grams weight
IDENTIFICATION DURABILITY: 1 25 cycles (250 strokes) (min), 500 grams weight
WIRE LENGTH REQUIREMENTS: Schedule A
SUPERSESSION DATA: The wire of this specification sheet, by part number, replaces and supersedes the wire of MS21 985(AS) (canceled) in accordance with Table III. MS21 985(AS) included wire sizes 28 through 1 6 only.

Share on Facebook

Post on X

Follow us

Save