SAE AS 17320-2000 pdf download MOUNTING DEVICES FOR AIRCRAFT ELECTRIC EQUIPMENT, QUICK ATTACH-DETACH, CIRCULAR, 5-, 8-, AND 10-INCH
NOTES:
1. SPECIFICATION: DATA FOR MIL-E-81099 ARE AS FOLLOWS (INITIAL NUMBERS REFER TO PARAGRAPHS OF THE SPECIFICATION)
1.2 CLASSIFICATION: THE MS PART NUMBERS OF THE DEVICES SHALL BE AS LISTED ON SHEET 2.
3.2 DIMENSIONS: THE DIMENSIONS OF EACH DEVICE SHALL BE AS SHOWN AND LISTED ON SHEET 2. ALL DIMENSIONS ARE IN INCHES. EACH DEVICE SHALL CONFORM TO THE DIMENSIONS SHOWN AND LISTED ON SHEET 2 WHEN THE DEVICE IS INSTALLED ON A DRIVE PAD AND AN EQUIPMENT IS INSTALLED IN THE DEVICE,AND ALSO WHEN THE DEVICE IS INSTALLED ON A DRIVE PAD AND THE DEVICE IS OPEN, AS NECESSARY, TO INSTALL AN EQUIPMENT IN THE DEVICE OR REMOVE AN EQUIPMENT FROM THE DEVICE.
3.3 SPECIAL REQUIREMENTS:
A. OPERATING MECHANISM: THE OPERATING MECHANISM SHALL POSITIVELY OPEN THE DEVICE AS WELL AS CLOSE IT, AND SHALL BE SELF-LOCKING, OR SHALL INCLUDE PROVISIONS FOR SAFETY-WIRING IT WHEN CLOSED.
3.5 PARTS: EACH DEVICE SHALL CONSIST OF ONLY ONE PART FOR PURPOSES OF INSTALLATION, AND NO PART OF THE DEVICE SHALL BECOME SEPARATED FROM THE REST OF THE DEVICE WHEN THE DEVICE IS OPEN AND NOT INSTALLED.
3.6 COLOR: NOT APPLICABLE.
3.7 WEIGHT: THE WEIGHT OF EACH DEVICE SHALL NOT EXCEED THE VALUE LISTED ON SHEET 2.
3.8 IDENTIFICATION MARKING: THE MANUFACTURER’S PART NUMBER AND THE MS PART NUMBER SHALL BE MARKED IN ACCORDANCE WITH MIL-STD-130 IN THE AREA SHOWN ON SHEET 2.
4.3.1 INDIVIDUAL TESTS: THE INDIVIDUAL TESTS SHALL BE THOSE OF 4.6.1, 4.6.2, AND 4.6.3.
4.3.2 SAMPLING TESTS: ONE DEVICE OUT OF EACH 100 SHALL BE SUBJECTED TO THE TEST OF 4.6.4.
4.5 TEST CONDITIONS: FOR THE EVALUATION TEST OF 4.6.4, THE DEVICE SHALL BE MOUNTED ON A DRIVE PAD CONFORMING TO MS18054 FOR THE NOMINAL SIZE OF THE DEVICE.
ADD 4.6.3.1 FIT: THE DEVICE SHALL BE TESTED TO DETERMINE THAT IT IS USABLE FOR CLAMPING THE MOUNTING FLANGE OF AN EQUIPMENT HAVING A MOUNTING FLANGE CONFORMING TO MS18056 FOR THE NOMINAL SIZE OF THE DEVICE, AND THAT IT CONFORMS TO THE SPECIAL REQUIREMENTS. (THE DEVICE NEED NOT BE INSTALLED ON A DRIVE PAD FOR THIS TEST.)
4.6.4 EVALUATION: THE DEVICE SHALL BE TESTED TO DETERMINE THAT IT IS USABLE FOR CLAMPING THE MOUNTING FLANGE OF AN EQUPMENT HAVING A MOUNTING FLANGE CONFORMING TO MS18056 FOR THE NOMINAL SIZE OF THE DEVICE. THE WEIGHT AND OVERHUNG MOMENT OF THE EQUIPMENT SHALL BE AS SPECIFIED ON SHEET 2. WHEN THE CLAMP IS OPEN, THE EQUIPMENT SHALL BE READILY REMOVABLE.
SAE AS 17320-2000 pdf download
PS:Thank you for your support!
