IEEE C63.14-1998 pdf download American National Standard Dictionary for Technologies of Electromagnetic Compatibility (EMC), Electromagnetic Pulse (EMP), and Electrostatic Discharge (ESD)
1.Scope
This standard provides definitions of terms associated with electromagnetic compatibility (EMC), electromagnetic pulse (EMP), and electrostatic discharge (ESD). In addition to definitions, symbols and abbreviations are included.
2. References
This standard shall be used in conjunction with the following publications. If the following publications aresuperseded by an approved revision, the revision shall apply.
ANSI C63.4-1992 American National Standard Methods of Measurement of Radio-Noise Emissions fromLow-Voltage Electrical and Electronic Equipment in the Range of 9 kHz to 40 GHz.”
ANSI C63.7-1992,American National Standard Guide for Construction of Open-Area Test Sites for Per-forming Radiated Emission Measurements.
ESD-ADV 1.0-1994 Glossary.
ESD ADV 2.0-1994. ESD Association Advisory for Protection and Sensitivity Testing of Electrostatic Dis-charge Susceptible Items.
FCC 47 CFR Part 15, Radio Frequency Devices (1990).3
3. Quantities, units, multiplying factors, symbols, and abbreviations
3.1 Quantities
The units and symbols listed in Table 1 shall be used to indicate the applicable quantity. The quantities, units, and unit symbols presented comply with the International System of Units (SI). (See IEEE Std 260.1- 1993 and IEEE/ASTM SI 10-1997.) In case of variance, this standard takes precedence.
3.2 Multiplying factors and symbols
The symbols listed in Table 2 shall be used to indicate the applicable multiplier.
3.3 Frequency spectrum designations and symbols
The symbols in Table 3 shall be used to indicate the applicable portion of the frequency spectrum.
3.4 Abbreviations and acronyms
AMN ArtiÞcial Mains Network (See LISN)
ANSI American National Standards Institute
BER bit-error-rate
C-E communication-electronic
CE conducted emission
CI conducted immunity
CISPR International Special Committee on Radio Interference
CS conducted susceptibility
dB decibel
dB(A) decibels referenced to 1 ampere
dBm decibels reference to 1 milliwatt
dB(mV) decibels referenced to 1 microvolt
dB(mV/m) decibels referenced to 1 microvolt per meter
ECCM electronic counter-countermeasure
ECM electronic countermeasure
EFS electric Þeld strength
EIA Electrical Industries Association
EIRP equivalent isotropic radiated power
EM electromagnetic
EMC electromagnetic compatibility
EMCP electromagnetic compatibility program
EMCS electromagnetic compatibility standardization
EMI electromagnetic interference
EMCM electromagnetic compatibility margin
EMP electromagnetic pulse
EMS electromagnetic susceptibility
EMV electromagnetic vulnerability
ERP effective radiated power
ESD electrostatic discharge
EUT equipment under test
EW electronic warfare
FCC Federal Communications Commission
FDA Food and Drug Administration
FIM Þeld-intensity meter
FSM Þeld-strength meter
FSVM frequency-selective voltmeter
GHz gigahertz
GTEM gigahertz transverse electromagnetic cell
HERF hazards of electromagnetic radiation to fuel
HERO hazards of electromagnetic radiation to ordnance
HERP hazards of electromagnetic radiation to personnel
HIRF high intensity radiated Þeld(s)
Hz hertz
IBW impulse bandwidth
IEEE Institute of Electrical and Electronics Engineers
IF intermediate frequency
IG impulse generator
IEC International Electrotechnical Commission
ISM industrial, scientiÞc, medical
ISO International Organization for Standardization
kHz kilohertz

Share on Facebook

Post on X

Follow us

Save