EN 60603-6-1998 pdf download.Connectors for frequencies below 3 MHz for use with printed boards Part 6: Edge-socket connectors and printed-board connectors with 2,54 mm (0,1 in) contact spacing for single or double-sided printed boards of 1,6 mm (0,063 in) nominal thickness.
This EN 60603-6 covers a range of connectors with 2.54 mm (0.1 in) contact spacing intended to connect a single or double-sided printed hoard to another printed hoard or wires.
Two kinds are available:
Edge-socket connector
A connector with female contacts intended to mate with edge-board contacts and with printed-board connectors having male contacts.
Edge-socket connectors are available with:
— solder terminations for wire:
— solder terminations for board mounting;
— wrap terminations. Printed-hoard connector
A connector having male contacts which when mounted on a printed hoard replaces the edge-hoard contacts.
Printed-board connectors are provided with solder terminations for single or double-sided boards of 1.6 mm (0.063 in) nominal thickness.
An edge-socket connector mated with a printed-board connector is referred to as a two-part connector in this standard.
The mandatory method of locating is by means of a guide key which replaces an opposite pair of contacts, and one such key is provided per connector (see also Sub-clause 4.5)
This standard shall be used in conjunction with the following IEC publications:
Nos. 50 (581)(1978): International Electrotechnical Vocabulary, Chapter 581: Electromechanical Components for Electronic Equipment
603-1 (1981): Connectors for Frequencies Below 3 MHz for Use with Printed Boards, Part 1: General Rules and Guide for the Preparation of Detail Specifications.
512-2 (1976): Electromechanical Components for Electronic Equipment; Basic Testing Procedures and Measuring Methods, Part 2: General Examination, Electrical Continuity and Contact Resistance Tests. Insulation Tests and Voltage Stress Tests.
512-3 (1976): Part 3: Current-carrying Capacity Tests.
512-6 (1984): Part 6: Climatic Tests and Soldering Tests.
No. of detail specification/IEC: 60:3-6 IEC
Style: As shown in Clauses 3 and 4 of this standard.
Number of ways: Digits denoting the number of contact locations along one side of the connector. Maximum 85 for Styles 1, 2, 3 and 5. and 80 for Style 4.
Single or double-sided and active
contact row: A = single-sided, side A active, single row of terminations
B = single-sided, side 11 active, single row of terminations
E = single-sided, side A active, double row of terminations
F = single-sided, side B active, double row of terminations
D = double-sided, both sides active
Termination style: S = solder terminations for wire
B = solder terminations for printed board
W = wrap terminations
T = through-board solder, short termination
L = through-board solder, long termination
X through-board solder, extra long termination
Contact finish: A = gold alloy
Contact rcmovallreplaccnwnt
system: A = rear release/front removable/replaceable contacts
B = rear release/rear removable/replaceable contacts
C = front release/front removable/replaceable contacts
D = front release/rear removableireplaceable contacts
Variant: Digits identifying individual connector, parts and associated tools for replacement purposes.EN 60603-6-1998 pdf download.

Share on Facebook

Post on X

Follow us

Save