EN 2354-1988 pdf download.Aerospace series Eye-ends, threaded, control cable in corrosion resisting steel Dimensions and loads.
This EN 2354 specifies the characteristics of threaded eye-ends in corrosion resisting steel intended for the turnbuckles of aircraft control cables.
2 References
ISO 2020, Aerospace — Mechanical system parts — Preformed flexible steel wire rope for aircraft controls — Technical specifica t ion.
ISO 5855-1, Aerospace construction — MI threads — Part 1: Basic profile.
ISO 5855-2, Aerospace construction — MJ threads — Part 2: Dimensions for bolts and nuts.
EN 2363. Aerospace series — Locking clips for turnbuckles of control cables — Dimensions — Aerospace
series.
EN 2462, Steel FE-PA 13— Softened — Bars D4. < 100 mm — Aerospace series.
EN 2516. Aerospace series — Passivation of corrosion resistant steels’.
EN 2569. Aerospace series — control cable fittings and turnbarrels — Technical specification1.
3 Required characteristics
3.1 Dimensions — Tolerances — Loads — Mass
The configuration shall correspond to the Figure and the dimensions shall conform to the values given in the Figure and the Table.
3.2 Surface roughness
See Figure.
3.3 Material
Steel EN 2462.
3.4 Surface treatment
Passivation EN 2516.
Where the following codes are applied for the thread direction:
R = right-hand thread
L = left-hand thread
NOTE If necessary, originator code S9005 may be introduced between the description block and identity block.
5 Marking
In addition to the manufacturer’s own marking, each threaded eye-end shall be marked (see Figure) using the identity block as defined in clause 4 of this standard.
The marking method is to the manufacturer’s option.
6 Technical specification
The threaded eye-ends supplied according to this standard shall conform with the requirements of
EN 2569.EN 2354-1988 pdf download.
EN 2354-1988 pdf download
PS:Thank you for your support!