EN 2286-1989 pdf download

07-21-2021 comment

EN 2286-1989 pdf download.Aerospace series Bushes, flanged aluminium alloy with self-lubricating liner Dimensions and loads.
This EN 2286 specifies the characteristics of flanged hushes in aluminium alloy with self-lubricating liner and the design recommendation of shafts and housings.
2 Field of application
The bushes are intended for operation within the temperature range of — 55 °C to + 150 °C and assembly with an interference fit into fixed and moving aerospace parts.
3 References
EN 2086, Aluminium alloy 2618A-T851 (A1-P11-T851)— Forged bars and slabs a ≤ 150 mm—Aerospace
series 1)
EN 2101, Aerospace series — Chroniic acid anodizing of aluminium and wrought aluminium alloysB.
EN 2284. Aerospace series — Sulphuric acid anodizing of aluminium and wrought aluminium alloys’.
EN 2311, Aerospace series — Bushes with self lubricating liners — Technical specification.
4 Required characteristics
4.1 Configuration — Dimensions — Tolerances — Masses
Configuration: see Figure 1.
Dimensions, tolerances and masses: see Figure 1 and Table 1.
Dimensions and tolerances apply after surface treatment.
4.2 Surface roughness
See Figure 1.
4.3 Materials
Bush: Aluminium alloy EN 2086.
Liner: Self-lubricating wear resistant material consistent with the requirements of EN 2311.
4.4 Surface treatment
Chromic acid anodizing EN 210 IA.
Sulphuric acid anodizing EN 2284A.
6 Marking
In addition to the manufacturer’s own marking each bush and its package shall be marked with the identity block specified in clause 5 of this standard.
Marking position and method are at manufacturer’s option, and shall not have any detrimental effect on the bush.
7 Technical specifIcation
Bushes supplied to this standard shall conform with the requirements of technical specification EN 2311.
The loads given in Table 2 of this standard are only applicable under the conditions given in EN 2311.
8 Design recommendation
Bushes defined by this standard are intended to be installed by interference fit methods (see Figure 2). Therefore, the loads given in Table 2 can only be insured if the following mounting is applied.EN 2286-1989 pdf download.

                                           Related Information                                             Download
PS:Thank you for your support!
EN 152-1:1988 pdf download EN Standards

EN 152-1:1988 pdf download

EN 152-1:1988 pdf download,Test methods for wood preservatives;Laboratory method for determining the preventive effectivenessof a preservative treatment against blue stain in service Part 1:Brushing procedure. The test method described in this European Standard is a laboratory method...
Read More
EN 74:1988 pdf download EN Standards

EN 74:1988 pdf download

EN 74:1988 pdf download.Cooplers,loose spigots and base-plates for use in working scaffolds and falsework made of steel tubes; Requirements and test procedures Key words Steel tubes,Scaffolding,Fasteners,Pipe fittings,Centring pins,Supports,Equipment specifications,Inspection methods,Sampling,Mechanical tests.
Read More
EN 50061:1988 pdf download EN Standards

EN 50061:1988 pdf download

EN 50061:1988 pdf download,Safety of implantable cardiac pacemakers. This standard EN 50061:1988 specifies safety and other requirementsexclusively for all types of wholly implantable cardiac PACEMAKERS. This standard EN 50061:1988 also establishes basic terminology and definitions and includes...
Read More

LEAVE A REPLY

Anonymous netizen Fill in information