EN 10060-2003 pdf download.Hot rolled round steel bars for general purposes – Dimensions and tolerances on shape and dimensions.
This EN 10060 specifies the nominal dimensions and the tolerances on dimensions and shape of hot-rolled round steel bars.
2 Normative references
This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text, and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies (including amendments).
EN 10079:1992, Definition of steel products.
EN 10088-1, Stainless steels — Part 1: List of stainless steels.
3 Terms and definitions
For the purposes of this European Standard, the terms and definitions given in EN 10079:1992 apply.
4 Designation
The designation of hot-rolled round steel bars shall comprise:
— the term round bar
— the number of this European Standard (EN 10060);
— dimensions in mm (diameter and length (M, F or E, see Table 4)):
— tolerance class P, if necessary;
— the number of the quality standard and the steel name or steel number of the ordered steel.
EXAMPLE 1
Round bar EN 10060 40x6000M
steel EN 10025 – S23SJR
EXAMPLE 2
Round bar EN 10060 – 26.65x3600F – P steel EN 10083-1 – 42CrMo4
5 Dimensions
Hot rolled round bars for general purposes complying with this European Standard shall be delivered with the specified dimensions range given in Table 1 and illustrated in Figure 1. The preferred dimensions are pesented in Table 1.
Hot rolled round bars for precision purposes complying with this European Standard shall be delivered with the specified dimensions range given in Table 1 and Table 2.
6 Tolerances on dimensions and shape
6.1 Diameter (c
The deviation from nominal diameter (c shall be within the tolerance given in Table 1 and Table 2.
NOTE In the Table 1 there are two tolerance classes, normal and precision (P).
6.2 Length (L)
Depending on the type of length the bars shall be cut to lengths within tolerances given in Table 4.
6.3 Straightness (q)
The straightness shall comp4y with the requirements given in Table 3. The requirements for waviness
may be agreed at the time of enquiry and order.
6.4 Ovality
The deviation for roundness shall not exceed 75% of the tolerance range given in Table 1 and Table 2.
7 Measurement
7.1 Diameter
The diameter shall be measured at any point situated at least 100 mm from the end of the bar. Shearing may deform the bar ends. The condition of the ends may be agreed at time of enquiry and order.
7.2 Length
The length shall be measured as the longest length of the bar.
7.3 Straightness
The straightness shall be measured over the total length (L) of the bar.
7.4 Ovality
The ovality shall be measured as the difference of the greatest diameter and the smallest diameter in the same plane perpendicular to the axis of the bar. The ovality shall be measured at any point situated at least 100 mm from the end of the bar.EN 10060-2003 pdf download.
EN 10060-2003 pdf download
PS:Thank you for your support!
