BS EN ISO 17075-1:2017 download

11-18-2020 comment

BS EN ISO 17075-1:2017 pdf free download. Leather – Chemical determination of chromium(VI) content in leather – Part 1: Colorimetric method.
BS EN ISO 17075-1:2017 specifies a method for determining chromium(VI) in solutions leached from leather under defined conditions. The method described is suitable to quantify the chromium(VI) content in leathers down to 3 mg/kg.
2 Normative references
ISO 2418, Leather-Chemical, physical and mechanical and fastness tests-Sampling location;
ISO 3696, Water for analytical laboratory use-Specification and test methods;
ISO 4044: 2017, Leather-Chemical tests-Preparation of chemical test samples;
ISO 4684, Leather-Chemical tests-Determination of volatile matter.
4 Principle
Extractable chromium(VI) is leached from the sample in phosphate buffer at pH 7,0 to 8,0 and co-extracted coloured substances which influence the detection are removed by solid phase extraction if necessary. The chromium(VD) in solution oxidizes 1,5-diphenylcarbazide to 1, 5-diphenylcarbazone to give a red /violet complex with chromium which can be quantified photometrically at 540 nm.
5 Chemicals
All reagents used shall have at least analytical grade purity.
5.1 Extraction solution
Dissolve 22.8g dipotassium hydrogenphosphate, K2HP04: 3H20, in 1 000 ml water, adjusted to pH8,0±0,1 with phosphoric acid (5.3).Degas this solution with either argon or nitrogen (5.6)or ultrasonic bath.
Standard practice is to make up a fresh solution each day. However, the solution can be kept for up to one week in a refrigerator at (4+3)°C but shall be warmed to room temperature and degassed prior to use..
5.5 Chromium(VI)standard solution
Pipette 1 ml of solution (5.4)into a 1 000 ml volumetric flask and make up to the mark with extraction solution (5.1 ) One millilitre of this solution contains 1 ug of chromium.
The solution can be kept for up to one week in a refrigerator at (4 +3)°C but shall be warmed to room temperature prior to use.
A stock solution at this concentration evel of hexavalent chromium is an alternative available commercially.
5.6 Argon or nitrogen,oxygen-free
Preference should be given to argon as an inert gas instead of nitrogen because argon has a higher specific mass than air.

                                           Related Information                                             Download
PS:Thank you for your support!
BS EN 12607-3-2000 pdf download BS Standards

BS EN 12607-3-2000 pdf download

BS EN 12607-3-2000 pdf download.Methods of test for petroleum and its products — BS 2000-460.3: Bitumen and bituminous binders — Determination of the resistance to hardening under the influence of heat and air — Part 3: RFT...
Read More
EN 12329-2000 pdf download BS Standards

EN 12329-2000 pdf download

BS EN 12329-2000 pdf download.Corrosion protection of metals — Electrodeposited coatings of zinc with supplementary treatment on iron or steel. This BS EN 12329 specifies requirements for electrodeposited coatings of zinc on iron or steel witt supplementary...
Read More
BS EN 1430-2000 pdf download BS Standards

BS EN 1430-2000 pdf download

BS EN 1430-2000 pdf download.Methods of test for petroleum and its products — BS 2000-292:Bitumen and bituminous binders — Determination of particle polarity of bitumen emulsions (Identical with IP 292-2000). This BS EN 1430 specifies a method...
Read More

LEAVE A REPLY

Anonymous netizen Fill in information