BS/EN 4710-03-2018 pdf download.Aerospace series – Quick release fastening systems for non-structural applications Part 03: Spring clamp.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
DIN EN ISO 19598. Metallic coatings — Electroplated coatings of zinc and zinc alloys on iron or steel with supplementary CR(Vl) -free treatment (iSO 19598:2016)
Elf 2424.. Aerospace series — Marking of aerospace products
EtLl51, Aerospace series — Passivation of corrosion resisting steels and decontamination of
nickel base alloys
EN 4710-01, Aerospace series — Quick release fastening systems for non-structural applications — Part
01: Technical specification
EN 4710-02. Aerospace series — Quick release fastening systems for non-structural applications — Part
02: Spring clamp stud combination
EN 4710-06, Aerospace series — Quick release fastening systems for non-structural applications — Part
06: Stud — quick-release and locking
EN 4710-07. Aerospace series — Quick release fastening systems for non-structural applications — Part 07.’
Retaining grommet
ENJ.I324, Cold rolled narrow steel strip for heat treatment — Technical delivery conditions — Part 4:
Spring steels and other applications
EN 10151. Stainless steel strip for springs — Technical delivery conditions
EN 22768-1:1993, General tolerances — Part 1: Tolerances Jar linear and angular dimensions without individual tolerance indications (ISO 2768-1:1989)
EN 22768-2:1993. General tolerances — Part 2: Geometrical tolerances for features without individual tolerance indications (ISO 2768-2:1989)
3 Requirements
3.1 Configuration, dimensions, tolerances and mass
The configuration, dimensions, tolerances and mass shall conform with Figure 1 and Table 1. Tolerances not specified, shall be in accordance with ISO 2768-mK (EN 22J681;1993 and EN 22Z&82i993). Dimensions are unless otherwise specified per manufacturer’s option.
5 Marking
Marking shall be in accordance with EN 2424. style F.
6 Technical specification
Required tests for acceptance and qualification shall be in accordance to Table 4.BS/EN 4710-03-2018 pdf download.
BS/EN 4710-03-2018 pdf download
PS:Thank you for your support!
