BS/EN 2699-2019 pdf download.Aerospace series – Aluminium alloy (5086)- Annealed and straightened (Hill) –
Drawnbar-6mm≤D≤5Omm.
This BS/EN 2699 specifies the requirements relating to:
Aluminium alloy (5086)
Annealed and straightened (Hill)
Drawn bars
6 mm ≤ D ≤ 50 mm
for aerospace applications.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
EN 2044, Aerospace series — Round bars, drawn in aluminium and aluminium alloys — Tolerance class h 11 — Diameter 4 mm ≤ D ≤ 63 mm — Dimensions
EN 2045, Aerospace series — Square bars, drawn in aluminium and aluminium alloys — Tolerance class h 11 — Thickness 6 mm ≤ a 5 50 mm — Dimensions
EN 2046, Aerospace series — Hexagonal bars, drawn in aluminium and aluminium alloys — Tolerance class h 11 — Width across flats 7mm ≤ a ≤ 50 mm — Dimensions
EN 4258, Aerospace series — Metallic materials — General organization of standardization — Links between types of EN standards and their use
EN 4400-3, Aerospace series — Aluminium and aluminium alloy wrought products — Technical specification — Part 3: Aluminium and aluminium alloy bar and section
EN 4500-002, Aerospace series — Metallic materials — Rules for drafting and presentation of material standards — Part 2: Specific rules for aluminium, aluminium alloys and magnesium alloys 1)
3 Terms and definitions
No terms and definitions are listed in this document.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
. IEC Electropedia: available at http://www.electropedia.org/BS/EN 2699-2019 pdf download.
BS/EN 2699-2019 pdf download
PS:Thank you for your support!
