BS EN 1124-2:2014,Pipes and fittings of longitudinally welded stainless steel pipes with spigot and socket for waste water systems. Part:2 System S, forms and dimensions.BS EN 1124-2:2014 pdf free download.
Pipes and fittings of longitudinally welded, stainless ste with spigot and socket for waste water systems as specified in this part of EN 1124 and EN 1124-3 ed in gravity drainage systems in buildings.
For vacuum drainage systems and drainage systems or necessary to specify additional requirements and further dimensional specifications for nents and joints used in these systems.
Components specified in EN 1124-4 are use cuum drainage systems and for drainage systems in shipbuilding.
This European Standard applies to pipes and fittings of longitudinally welded stainless steel pipes with spigot and socket for waste water systems and specifies dimensions and tolerances for pipes, fittings and pipe connectors and establishes a system of designations for the different pipe and fitting types that conform to the stated requirements.
This part of EN 1124 is only valid in connection with EN 1124-1.
2 Normative references
EN 1124-1: 1999, Pipes and fittings of ongitudinal welded stainless steel pipes with spigot and socket for waste water systems-Part 1: Requirements, testing, quality control;
EN ISO 228-1, Pipe threads where pressure-tight joints are not made on the threads-Part 1: Dimensions, tolerances and designation (ISO 228-1);
5 Dimensions
5.1 General and tolerances
The figures in this document are simplified drawings. The dimensions given shall be followed.
Where no tolerances are given in this European Standard, tolerances for linear dimensions shall be followed in accordance with Table 1. tolerances for radii shall be followed in accordance with T able 2 and tolerance for angular dimensions, referring to the smaller side length, shall be followed in accordance with Table 3.
BS EN 1124-2:2014 pdf download
PS:Thank you for your support!