ASTM A1018/A1018M-16 pdf free download.Standard Specification for Steel, Sheet and Strip, Heavy-Thickness Coils, Hot-Rolled, Carbon, Commercial, Drawing, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, and Ultra-High Strength.
PS:ASTM A1018/A1018M-16 is replaced by ASTM A1018/A1018M-18.
ASTM A1018/A1018M-16 covers hot-rolled, heavy-thickness coils beyond the size limits of Specification A1011/A1011M.
Referenced Documents
ASTM A6/A6M Specification for General Requirements for Rolled Structural Steel Bars, Plates, Shapes, and Sheet Piling;
ASTM A635/A635M Specification for Steel, Sheet and Strip, Heavy-Thickness Coils, Hot-Rolled, Alloy, Carbon, Structural, High-Strength Low-Alloy, and High-Strength Low-Alloy with Improved Formability, General Requirements for;
ASTM A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products;
ASTM A941 Terminology Relating to Steel, Stainless Steel, Related Alloys, and Ferroalloys;
ASTM E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications;
ASTM G101 Guide for Estimating the Atmospheric Corrosion Resistance of Low-Alloy Steels;
8. Mechanical Properties
8.I Test specimen preparation and mechanical testing shall be in accordance with Test Methods and Definitions A370.
2 Tensile Properties-The material, structural steel, high-strength low-alloy steel, high-strength low-alloy steel with improved formability, and ultra-high strength steel, as repre- sented by the test specimens shall conform to the mechanical property requirements as stated in Table 5. These requirements do not apply to the uncropped ends of unprocessed coils.
8.3 Tension Test Specimen Location and Orientation- Tension test specimens shall be taken sufliciently far from the as hot-rolled coil ends so that the sample is representative of material which received the designed processing. The test shall be taken approximately midway between the center and edge of the material as rolled, For coils wider than 24 in. 600 mmI Tension test specimens shall be taken such that the longitudinal axis of the specimens is perpendicular to the direction of rolling (transverse test ) For coils through 24 in. [600 mm in width, tension test specimens shall be taken such that longitu dinal axis of the specimen is parallel to the direction of rolling (longitudinal test).
ASTM A1018/A1018M-16 pdf download
PS:Thank you for your support!
