ASME B30-20:2006 pdf download Below-the-Hook Lifting Devices
SECTION Il: SCOPE EXCLUSIONS
The B30 Standard does not apply to track and automo-tive jacks, railway or automobile wrecking cranes, shipboard cranes,shipboard cargo-handling equipment,well-drilling derricks, skip hoists, mine hoists, truckbody hoists, car or barge pullers, conveyors, excavatingequipment,or equipment covered under the scope ofthe following standards: A10, A17, A90,A92, A120, B20B56,and B77.
SECTION Ill: PURPOSE
The B30 Standard is intended to
(a) prevent or minimize injury to workers, and other-wise provide for the protection of life, limb, and propertyby prescribing safety requirements(b) provide direction to manufacturers,ownersemployers, users, and others concerned with, or respon-sible for, its application
(c) guide governments and other regulatory bodiesin the development, promulgation, and enforcement ofappropriate safety directives
SECTION IV: USE BY REGULATORY AGENCIES
These Volumes may be adopted in whole or in partfor governmental or regulatory use. If adopted for gov-ernmental use, the references to other national codesand standards in the specific volumes may be changedto refer to the corresponding regulations of the govern-mental authorities.
SECTION V: EFFECTIVE DATE
(a) Effective Date. The effective date of this Volume ofthe B30 Standard shall be 1 year after its date of issuance.
Construction,installation,inspection,testing,maintenance, and operation of equipment manufactured andfacilities constructed after the effective date of thisVolume shall conform to the mandatory requirementsof this Volume.
(b) Existing Installations. Equipment manufacturedand facilities constructed prior to the effective date ofthis Volume of the B30 Standard shall be subject to theinspection,testing, maintenance, and operation requirements of this Standard after the effective date.
It is not the intent of this Volume of the B30 Standardto require retrofitting of existing equipment. However,when an item is being modified, its performance requirements shall be reviewed relative to the requirementswithin the current volume. The need to meet the currentrequirements shall be evaluated by a qualified personselected by the owner (user). Recommended changesshall be made by the owner (user) within 1 year.
SECTION VI: REQUIREMENTS ANDRECOMMENDATIONSRequirements of this Standard are characterized byuse of the word shall. Recommendations of this Standardare characterized by the word should.
SECTION VIl: USE OF MEASUREMENT UNITS
This Standard contains SI (metric) units as well asU.S. Customary units. The values stated in customaryunits are to be regarded as the standard. The SI unitsare a direct (soft) conversion from the customary units
SECTION VIIl: REQUESTS FOR REVISION
The B30 Standards Committee will consider requestsfor revision of any of the volumes within the B30Standard. Such requests should be directed to:
Secretary, B30 Standards CommitteeASME Codes and StandardsThree Park AvenueNew York,NY 10016-5990
Requests should be in the following format:Volume:Cite the designation and title of the volume.Cite the applicable edition of the volume.
Edition:
Subject:
Cite the applicable paragraph number(s)and the relevant heading(s).
ASME B30-20:2006 pdf download
PS:Thank you for your support!
