API STD 660:2001 pdf download

12-17-2022 comment

API STD 660:2001 pdf download.Shell–and–Tube Heat Exchangers for General Refinery Services
3.2.4 Upon receipt of the purchaser’s review comments on the outline drawings, the vendor shall submit copies of all detail drawings for the purchaser’s review. The detail drawings shall fully describe the heat exchanger and shall include, but not be limited to, the fol- lowing information: a. Full and cross section views with all dimensions and mate- rials sufficient for stress calculations for each part. b. Bundle details, including tube layout; tube description and number in each pass; cross baffle cut, layout, and orientation in a view that shows the cuts; details and locations of all bypass seals; and tubesheet and tube-hole details, including cladding when required. c. Details of each pressure-retaining weld, including weld material, weld location, and applicable non-destructive exam- ination method. d. Details of each weld for non-pressure attachments. e. Complete bills of materials, including the ASME specifi- cation number. f. Expansion joint details. g. Details of cladding and weld overlay. h. A weld map for each heat exchanger showing the weld joints, including welding procedure number(s). i. Details of tube-to-tubesheet joints including procedure for installation, welding, expansion, inspection, and testing. j. Flange-face finish.
3.3 FINAL RECORDS
After the heat exchanger is completed, the vendor shall fur- nish the purchaser with the specified number of copies of the following documents: a. An “as-built” specification sheet. b. All outline and detail drawings, marked “CERTIFIED AS- BUILT”. c. A certified record of all impact tests performed. d. Certified mill test reports for all pressure parts, including tubes (each material test report shall be identified by part number). e. A complete certified bill of materials suitable for obtaining all replacement parts, including quantity, description, mate- rial specification, and identification of each part. f. Temperature charts of all postweld heat treatments. g. A completed manufacturer’s data report in accordance with ASME Code, Section VIII, Division 1. h. Nameplate rubbings or a facsimile. i. All mechanical design calculations, marked “CERTIFIED AS-BUILT”. j. A non-destructive testing map or procedure for each heat exchanger showing the radiographic, magnetic-particle, liq- uid-penetrant, ultrasonic, hardness, impact, and other applicable testing requirements. k. Tube-joint leak-test results. l. Hydrostatic test records in the form of a chart or certification.

                                           Related Information                                             Download
PS:Thank you for your support!
API TR 10TR2:1997(R2002) pdf download API Standards

API TR 10TR2:1997(R2002) pdf download

API TR 10TR2:1997(R2002) pdf download.Shrinkage and Expansion in Oilwell Cements 4.1.1 Some equipment measures the external volume change. Other equipment measures the volume of fluid intake or expulsion during the hydration. Measurement of V, and y must...
Read More
API Std 1104:2005 pdf download API Standards

API Std 1104:2005 pdf download

API Std 1104:2005 pdf download.Welding of Pipelines and Related Facilities 1.1 SCOPE This standard covers the gas and arc welding of butt, fillet, and socket welds in carbon and low-alloy steel piping used in the compression, pumping,...
Read More
API STD 613:2003 pdf download API Standards

API STD 613:2003 pdf download

API STD 613:2003 pdf download.Special Purpose Gear Units for Petroleum, Chemical and Gas Industry Services 1.1 SCOPE This standard covers the minimum requirements for spe- cial-purpose, enclosed, precision single- and double-helical one- and two-stage speed increasers and...
Read More

LEAVE A REPLY

Anonymous netizen Fill in information