ANSI Z245.5-2004 pdf download Equipment Technology and Operations for Wastes and Recyclable Materials –- Baling Equipment – Safety Requirements for Installation, Maintenance, Modification, Repair and Operation
1. Scope
1.1 This standard revises safety requirements with respect to the installation, operation, maintenance, service, repair, modification, and reconstruction (where applicable) of baling equipment covered by ANSI Z245.5 – 2008, Baling Equipment – Safety Requirements.
1.2 The requirements of this standard apply to balers rated at 600 volts or less, for outdoor or indoor use, and are employed in accordance with the manufacturer’s written installation, operation, and maintenance instructions and procedures.
2. Normative references
This standard is intended to be used with the following American National Standards. When these standards are referenced, the most recent revision shall apply:
ANSI Z245.51, Baling Equipment — Safety Requirements
ANSI/NFPA 70, National Electrical Code
ANSI/NFPA 70E, Standard for Electrical Safety in the Workplace
The following regulations contain provisions which, through reference in this text, constitute provisions of this American National Standard.
OSHA 29 CFR Part 1910.23, Guarding of Floor and Wall Openings and Holes
OSHA 29 CFR Part 1910.132, General Requirements for Personal Protective Equipment
OSHA 29 CFR Part 1910.146, Permit Required Confined Spaces
OSHA 29 CFR Part 1910.147, Control of Hazardous Energy Sources (Lockout/Tagout)
OSHA 29 CFR Part 1910, Subpart S, Electrical
3. Definitions
The definitions below apply to items used throughout this standard unless the context clearly requires otherwise.
3.1 access cover or door: A panel covering an opening that is designed to permit access to the interior of the baler (includes hopper access doors and loading doors).
3.2 access gate: A moveable barrier/guard that swings on hinges or moves in/on a track and is distinguished from a door by having openwork.
3.3 affected employee: An employee whose job functions place him/her in proximity to potential hazards related to work being performed by authorized employees.
3.4 arc flash: A sudden release of electrical energy through the air when a high-voltage gap exists and there is a breakdown between conductors. An arc flash gives off thermal radiation (heat) and bright, intense light that can cause burns. High-voltage arcs can also produce considerable pressure waves by rapidly heating the air and creating a blast.
ANSI Z245.5-2004 pdf download
PS:Thank you for your support!
