ANSI Z245.41-2004 pdf download

01-20-2023 comment

ANSI Z245.41-2004 pdf download Equipment Technology and Operations for Wastes and Recyclable Materials — Facilities for the Processing of Commingled Recyclable Materials – Safety Requirements
1.1 Scope
This American National Standard is applicable to all persons who design, manufacture, assemble, modify, operate, clean, maintain, service, or repair material recovery facilities (MRFs) which engage in receiving, storing, and processing commingled recyclable materials which have been previously collected or otherwise diverted from the solid waste stream. This standard does not apply to scrap processing facilities (North American Industry Classification system code number 421 93, formerly Standard Industrial Classification number 5093), unless the scrap processing facility operates a MRF, which MRF would then be subject to this standard. The safety requirements are divided into 7 sections and are applicable as described in 1 .1 .1 through 1 .1 .3.
1.1.1 Sections 1 through 3 provide general information and definitions and shall apply to all material recovery facilities (MRFs) covered by this standard.
1.1.2 Sections 4 through 6 provide for physical plant, processing machinery and mobile equipment requirements that shall apply to both new and existing MRFs.
1.1.3 Section 7 provides for safety programs and safety requirements that shall apply to both new and existing MRFs.
1.2 Purpose This standard establishes safety requirements with respect to the design, manufacture, installation, reconstruction, modification, maintenance, and operation of facilities for the processing of commingled recyclable materials.
1.3 Effective date The effective date of sections four, five, and six of this standard for existing facilities shall be two (2) years after the approval date of this standard by the American National Standards Institute. Training and employer requirements sections shall be effective six (6) months after the approval date of this standard. All facilities placed in operation eighteen (1 8) months after the approval date of this standard shall be designed, constructed and operated in accordance with the requirements of this standard.
2 Normative references
This standard is intended to be used with the following American National Standards. When these referenced standards are superseded by a revision approved by the American National Standards Institute, the revision shall apply:
ANSI/ASME B20.1 -2001 , Safety Standard for Conveyors and Related Equipment
ANSI/ASME B56.1 -2000, Safety Standard for Low Lift and High Lift Trucks (Powered and Non-Powered Industrial Trucks)
ANSI/ASME B56.1 a-2001 , Addenda to Safety Standard for Low Lift and High Lift Trucks
ANSI Z41 -1 999, Personal Protection – Protective Footwear
ANSI/ASSE Z87.1 -2003, Practice for Occupational and Educational Eye and Face Protection
ANSI Z89.1 -2003, Personal Protection-Protective Headwear for Industrial Workers-Requirements
ANSI Z245.1 -1 999, Mobile Wastes and Recyclable Materials Collection, Transportation and Compaction Equipment – Safety Requirements

                                           Related Information                                             Download
PS:Thank you for your support!
ANSI AWS A5.03-1999(R2007) pdf download ANSI Standards

ANSI AWS A5.03-1999(R2007) pdf download

All standards (codes, specifications, recommended practices, methods, classifications, and guides) of the American Welding Society (AWS) are voluntary consensus standards that have been developed in accordance with the rules of the American National Standards Institute (ANSI). When...
Read More
ANSI AWS A5.20-1995 pdf download ANSI Standards

ANSI AWS A5.20-1995 pdf download

Note: The primary purpose of AWS is to serve and benefit its members. To this end, AWS provides a forum for the exchange, consideration, and discussion of ideas and proposals that are relevant to the welding industry...
Read More

LEAVE A REPLY

Anonymous netizen Fill in information