ANSI SCTE-123-2011 pdf download Specification for “F” Connector, Male, Feed-Through
1.0 SCOPE The purpose of this document is to specify requirements for male “F” feed-through connectors that are used in the 75 ohm RF broadband communications industry. This specification applies to SCTE drop cable specifications ANSI/SCTE 74 2003, ANSI/SCTE 71 2008, and ANSI/SCTE 100 2010. All requirements of this document are measured after installation per manufactures instructions of the cable into the connector.
2.0 DEFINITIONS AND ACRONYMS
2.1 Dielectric: The material that is used to insulate the center conductor from contacting the outer housing. 2.2 Thread Relief: A reduced diameter section of the threaded surface to allow the tool to run out. This feature is optional.
2.3 Center Conductor: The inner conductor of a coaxial cable that is fed through the male “F” feed-through connector.
2.4 Reference Plane: The reference plane on the male “F” feed-through connector is the mating surface that seats against the female “F” port. It is also the plane from where all horizontal dimensions are taken.
2.5 Parting Line (relevant to casting process only): A raised mark left on the surface of a part as a result of the gap between two halves of a die.
3.0 NORMATIVE REFERENCES The following documents contain provisions, which, through reference in this text, constitute provisions of this standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreement based on this standard are encouraged to investigate the possibility of applying the most recent editions of the documents listed below.
3.1 SCTE References
ANSI/SCTE 60 2010, Test Method for Interface Moisture Migration
ANSI/SCTE 74 2003, Specification for Braided 75 Ohm Flexible RF Coaxial Drop Cable
ANSI/SCTE 71 2008, Specification for Braided, 75 Ohm, Coaxial Multi-Purpose Cable
ANSI/SCTE 98 2009, Test Method for Withstand Tightening Torque – ‘F’ Male
ANSI/SCTE 99 2009, American National Standard Test Method for Axial Pull Connector/Cable
ANSI/SCTE 100 2010, Specification for 75 Ohm Smooth Aluminum Access Cables
ANSI/SCTE 103 2004, Test Method for DC Contact Resistance
ANSI/SCTE 01 2006, Specification for “F” Port, Female, Outdoor
ANSI/SCTE 02 2006, Specification for “F” Port, Female, Indoor
ANSI/SCTE 143 2007, Test Method for Salt Spray
3.2 Standards from other Organizations—Not applicable.
ANSI SCTE-123-2011 pdf download
PS:Thank you for your support!
