ANSI SCTE 123-2006 pdf download Specification for “F” Connector, Male, Feed-Through
1.0 SCOPE
The purpose of this document is to specify requirements for male “F” feed-through connectors that are used in the 75 ohm RF broadband communications industry. This specification applies to SCTE drop cable specifications ANSI/SCTE 74 2003, ANSI/SCTE 71 2003, ANSI/SCTE 100 2004, IPS SP 005 and IPS SP 006.
All requirements of this document are measured after installation per manufactures instructions of the cable into the connector.
2.0 DEFINITIONS AND ACRONYMS
2.1 Dielectric: The material that is used to insulate the center conductor from contacting the outer housing.
2.2 Thread Relief: A reduced diameter section of the threaded surface to allow the tool to run out. This feature is optional.
2.3 Center Conductor: The inner conductor of a coaxial cable that is fed through the male “F” feed-through connector.
2.4 Reference Plane: The reference plane on the male “F” feed-through connector is the mating surface that seats against the female “F” port. It is also the plane from where all horizontal dimensions are taken.
2.5 Parting Line (relevant to casting process only): A raised mark left on the surface of a part as a result of the gap between two halves of a die.
3.0 NORMATIVE REFERENCES
The following documents contain provisions, which, through reference in this text, constitute provisions of this standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreement based on this standard are encouraged to investigate the possibility of applying the most recent editions of the documents listed below.
3.1 SCTE References
ANSI/SCTE 60 2004 (formerly IPS TP 013), Test Method for Interface Moisture Migration
ANSI/SCTE 74 2003 (formerly IPS SP 001), Specification for Braided 75 Ohm Flexible RF Coaxial Drop Cable
IPS SP 400, Specification for “F” Port, Female, Outdoor
IPS SP 406, Specification for “F” Port, Female, Indoor
IPS TP 406, Test Method for Salt Spray
3.2 Standards from other Organizations—Not applicable.
4.0 INFORMATIVE REFERENCES
The following documents may provide valuable information to the reader but are not required when complying with this standard.
ANSI SCTE 123-2006 pdf download
PS:Thank you for your support!
