ANSI CTA-885-2007 pdf download Remote Starter Safety ANSI/CEA-885 R-201 3 April 2007
3 Run Time Any remote starter complying with this standard shall not have a run-time of greater than continuous 30 minutes under any circumstances. In addition, cumulative run times (without customer intervention) – for example, in a self starting mode which may be looking to start the vehicle when the temperature or battery voltage drops–shall not exceed more than 30 minutes in any two hour period, excepting where the vehicle stalls.
4 In-Gear Detection Any remote starter complying with this standard shall incorporate a feature preventing a vehicle from starting or driving off after starting the remote starter. In particular, a remote starter shall not start if the vehicle is in-gear. And, if the vehicle is shifted into gear, then the vehicle shall immediately shut down. If any special steps are necessary for the installer to insure this is met – these steps in the directions shall be clearly marked in bold print and with some wording giving the installer ample warning of the issues.
5 Safety Inputs Provisions for each of the safety inputs identified in Sections 5.1 , 5.2 or 5.3 shall be directed in the manual as required inputs on the product. In addition, before starting the vehicle for the first time, the remote starter shall verify that at least one of the safety inputs is connected.
5.1 Hood Input Activating an input after the vehicle has been started via remote start control should terminate remote start operation. If the hood input is active (for example, the hood is opened) at the time a start sequence is initiated, the vehicle shall not start.
5.2 Brake Input An input shall be provided from the brake switch to terminate an existing run cycle or prevent the vehicle from starting via remote start.
5.3 Service “Valet” Mode The service or “valet” mode can contribute to the safety of the vehicle when it is in service to prevent injury. If a start sequence is initiated while the system is in service mode, the system shall not start.
6 Vehicle Security Integrity Many vehicles that will have a remote starter installed will have an existing security system already in place. The installed remote starter shall interface with the vehicle security system in a manner that does not disable, or compromise, the existing vehicle security system, except during run-time.
ANSI CTA-885-2007 pdf download
PS:Thank you for your support!
