AIA/NAS-622-2010 pdf download HOOK, SUPPORT, ELECTRONIC EQUIPMENT CLAMP
CODE:
MATERIAL CODE: “–” = CADMIUM PLATED STEEL
“C” = CRES
TYPE CODE: “T” = VERTICAL TYPE SUPPORT HOOK
“E” = HORIZONTAL TYPE SUPPORT HOOK
ATTACHMENT FASTENER CODE: “1 ” = 6-32 SCREW
“2” = NAS51 4 SCREW OR SIMILAR SCREW
“3” = MS20427 RIVET OR SIMILAR RIVET
“4” = PILOT HOLE
EXAMPLE OF PART NUMBER:
NAS622–T1 = HOOK, SUPPORT, CADMIUM PLATED STEEL, VERTICAL TYPE, USING 6-32 SCREW FASTENER.
NAS622CE2 = HOOK, SUPPORT, CRES, HORIZONTAL TYPE, USING NAS51 4 SCREW OR SIMILAR SCREW FASTENER.
NOTES:
(1 ) ALL DIMENSIONS IN INCHES AND APPLY AFTER FINISH UNLESS OTHERWISE SPECIFIED.
(2) SURFACE TEXTURE SHALL BE IN ACCORDANCE WITH ASME B46.1 AND SURFACE TEXTURE SYMBOLS SHALL BE IN ACCORDANCE WITH ASME Y14.36M.
(3) TOLERANCES UNLESS OTHERWISE SPECIFIED:
DECIMALS (HUNDREDTH) ± .03
DECIMALS (THOUSANDTHS) ± .01 0
ANGLES ± 1 /2°
(4) INTENDED FOR USE WITH NAS573.
/5/ MAXIMUM ANGLE 92°.
(6) HOLES MUST BE ON CENTERLINE WITHIN .01 0 INCH.
/7/ UPPER TRIM OPTIONAL IF CONFINED WITHIN ENVELOPE SHOWN.
(8) REMOVE ALL BURRS AND SHARP EDGES.
(9) THIS STANDARD TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN.
(1 0) UNLESS OTHERWISE SPECIFIED, PART INVENTORY MANUFACTURED TO PREVIOUS REVISIONS OF THE APPLICABLE DRAWING OR SPECIFICATION MAY BE PROCURED AND USED UNTIL STOCK IS DEPLETED.
(1 1 ) REFERENCED DOCUMENTS SHALL BE THE ISSUE IN EFFECT ON DATE OF INVITATIONS FOR BID.
(1 2) DIMENSIONING AND TOLERANCING PER ANSI Y1 4.5M-1 982.

Share on Facebook

Post on X

Follow us

Save