AIA/NAS 1327-2011 pdf download SPACER, THRU-HOLE, SPLINE
NAS1327C06-8 = SPACER, SPLINE, FOR .143 SCREW OR BOLT SIZE, .226 “ØC”, .281 “ØE”, .250 LONG,CRES MATERIAL, PASSIVATED.
NAS1327-04-24E = SPACER, SPLINE, FOR .116 SCREW OR BOLT SIZE, .179 “ØC”, .219 “ØE”, .750 LONG,CARBON STEEL MATERIAL, ELECTROPLATED TIN.
NAS1327-06-20P = SPACER, SPLINE, FOR .143 SCREW OR BOLT SIZE, .226 “ØC”, .281 “ØE”, .625 LONG,CARBON STEEL MATERIAL, CADMIUM PLATED.
NOTES:
(1) DIMENSIONS IN INCHES AND APPLY AFTER FINISH UNLESS OTHERWISE SPECIFIED.
(2) REMOVE ALL BURRS AND SHARP EDGES.
(3) SURFACE ROUGHNESS SHALL NOT EXCEED 125
MICROINCHES Ra PER ASME B46.1.
(4) THIS STANDARD TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN.
(5) UNLESS OTHERWISE SPECIFIED, PART INVENTORY MANUFACTURED TO PREVIOUS REVISIONS OF THE APPLICABLE DRAWING OR SPECIFICATION MAY BE PROCURED AND USED UNTIL STOCK IS DEPLETED.
(6) UNLESS OTHERWISE SPECIFIED HEREIN, REFERENCED DOCUMENTS SHALL BE THE ISSUE IN EFFECT ON DATE OF MANUFACTURE. HOWEVER, EXISTING MATERIAL INVENTORY CERTIFIED TO A PREVIOUS REVISION OF THE APPLICABLE MATERIAL SPECIFICATION(S) IS ACCEPTABLE FOR USE UNTIL DEPLETION.
(7) DIMENSIONING AND TOLERANCING PER ANSI Y14.5M-1982.
/8/ PUSH-OUT AND TORQUE-OUT VALUES SHALL BE AS SPECIFIED IN TABLE III WHEN PROPERLY INSTALLED IN .060 INCH MINIMUM THICK G-10 FIBERGLASS BOARD.

Share on Facebook

Post on X

Follow us

Save