AIA/NAS 10000-2013 pdf download NA DOCUMENTS PREPARATION AND MAINTENANCE IN SI (METRIC) UNITS
Purpose. The standard practices established in this document provide means of obtaining uniformity in thepreparation and maintenance of National Aerospace Standards prepared in the International System of Units (SIMetric) and shall be adhered to insofar as practicable. For preparation and maintenance of inch unit documentssee NAS380.
Classification
Document Classification, National Aerospace Standards Documents prepared in accordance with this standardpractice shall be classified as one of the following:
Part Standard. A standard which completely defines a stockable detail or assembly with respect to material, finish
size,shape.and tolerance.Standard Practice. A standard setting forth drafting convention, symbols, practices, etc; inspection methods.procedures, or standards; equivalent parts, processes, or standards (by means of a comparison table); or standarcterminology and definitions.
Design Standard. A standard depicting standardized features of design such as shape, controlling dimensions,tolerances, clearance dimensions, installation methods and requirements, engineering design considerations, andengineering requirements for manufacturing processes
Specification, A standard which determines the technical requirements of a standard part, or establishes thestandards for work to be accomplished; in general, describing the processes of operation, quality of materials, andgiving information not normally contained on related standard drawings
Requirement Identifier, The requirements defined in this standard practice shall be identified by the requirementidentifying numbers derived as shown in 5.2.2, 5.3.2 and 5.4.2.
REFERENCED DOCUMENTS
The following documents form a part of this standard practice to the extent specified herein.
Governmental
MIL-STD-961Military Specifications and Assorted Documents, Preparation OfCataloging Handbook H6Federal Item Name Directory for Supply Cataloging
Copies can be obtained from the Department of Defense Single Stock Point (DODSSP). http://dodssp.daps.dla.mi
Nongovernmental
ASTM InternationalASTM A342/A342MStandard Test Method for Permeability of Feebly Magnetic MaterialsASTM SI10American National Standard for Use of the International Svstem of Units (SI): The ModerrMetric System
Copies can be obtained from ASTM International,100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA19428-2959.wwwastm.org
ASME
ASME B46.1
ASME Y14.38
ASME Y14.100
Surface Texture
Abbreviations and Acronyms for Use on Drawings and Related Documents
Engineering Drawing Practices
Copies can be obtained from ASME, Three Park Ave., New York, NY 10016-5990. www.asmeorg
NA0043 Identification of Male Threaded Fasteners, Metric
NA0156 Design Parameters for Male Threaded Fasteners
NA* Design Parameters for Female Threaded Fasteners
NA* Design Parameters for Rivet Type Fasteners
NA* Design Parameters for Bearings
NA* Design Parameters for Fluid Fittings
NAS380 NAS Documents, Preparation and Maintenance in the Inch System of Units
NAS1495 Recommended Qualification Test Procedure for Compliance with NAS Specifications and Standard Drawings
NAS10001 Preferred Metric Units for the United States Aerospace Industry
Copies can be obtained from the Aerospace Industries Association, 1000 Wilson Blvd., Suite 1700, Arlington, VA 22209. www.aia-aerospace.org
American National Metric Council
ANMC Metric Editorial Guide
Copies can be obtained from the U.S. Metric Association, Inc. 2032 Mendon Drive, Rancho Palos Verdes, CA 902753. www.metric.org
AIA/NAS 10000-2013 pdf download
PS:Thank you for your support!
