Free Standards Download

EN 485-4-1993 pdf download.Aluminium and aluminium alloys — Sheet, strip and plate — Part 4: Tolerances on shape and dimensions for cold-rolled products. This Part of EN 485 specifies the tolerances on shape and dimensions for wrought...

EN 1592-1-1997 pdf download.Aluminium and aluminium alloys HF seam welded tubes Part 1: Technical conditions for inspection and deliveiy. More than one solution-treatment lot can be induded in a furnace load. N(YrE. For the heat treatment in...

EN 1301-1-2008 pdf download.Aluminium and aluminium alloys - Drawn wire - Part 1: Technical conditions for inspection and delivery. 6.1.1 Chemical analysis Samples fo chemical analysis shall be taken at the time of casting according to EN...

EN 754-6-2008 pdf download.Aluminium and aluminium alloys - Cold drawn rod/bar and tube - Part 6: Hexagonal bars, tolerances on dimensions and form. This EN 754-6 specifies the tolerances on dimensions and form for aluminium and aluminium...

EN 1706-2010 pdf download.Aluminium and aluminium alloys-Castings - Chemical composition and mechanical properties. This EN 1706 speciftes the chemical composition hmts for aluminmjrn casting alloys and mechanical properties ci separately cast test pieces for these alloys. Arviex...

EN 1676-2010 pdf download.Aluminium and aluminium alloys-Alloyed ingots for remelting Specifications. ingot for remelting metal cast into a form suitable for remelting wtilch has been processed, as appropnate. to adjust the chemical composition and to remove certain...

EN 941-2014 pdf download.Aluminium and aluminium alloys - Circle and circle stock for the production of general applications - Specifications. 2 Normative references The following documents, in whole or in part, are normatively referenced in this document...

EN 851-2014 pdf download.Aluminium and aluminium alloys - Circle and circle stock for the production of culinary utensils - Specifications. 2 Normative references The following documents, in whole or in part, are normati’ieIy referenced in this document...