Free Standards Download

AGMA 90FTM6-1990 pdf download

Rapid and destructive failures of high quality, high speed, lightweight and highly loaded aircraft gears are indication of the vibrational energy (associated with neutral frequency modes) exceeding the fatigue endurance limit of advance gear materials. This paper...

02-28

AGMA 90FTM5-1990 pdf download

Polishing wear has been known to occur on piston rings， cylinder bores, valve lifters， hydraulic components, rolling- -element bearings and gear teeth. The bright, polish surfaces may look good, but polishing wear is detrimental because it is...

02-28

AGMA 90FTM4-1990 pdf download

In the first part, this document describes all the types and aspects of wear which can occur on the gear teeth in operation, with causes and explanations concerning their appearance. For each type of wear, the possible...

02-28

AGMA 90FTM3-1990 pdf download

Worm-gear drives have been subject of intensive research. Geometry of worm-gear dr ives with ground worm surf aces and worm surfaces generated by blades have been. developed by (Litvin, 1968). (Winter et al, 1981) and (Octrue,1988) have...

02-28

AGMA 90FTM2-1990 pdf download

If the different rating methods usually used for designing worm gears (, a ) consider their limited life because of TEETH BREA-KAGE and CONTACT PRESSURES, experience shows that in most cases, it is the SURFACE DEGRADATIONS OF...

02-28

AGMA 88FTM13-1988 pdf download

This paper is concerned primarily with the development of a gear noise test facility which is currently being used to study the fundamental sources of gear noise excitation through the testing of carefully controlled pairs of gears....

02-28

AGMA 12FTM22-2012 pdf download

While eddy current technology has long been used in the testing of bar, tube, and wire stock, advances in electronics, automation, and coil design have paved the way for a new generation of testers specifically designed for...

02-28

AGMA 11FTM22-2011 pdf download

Gearbox efficiency is a topic of rising interest amongst both OEM and end-users due to an increased sensitivity to gearbox performance, reliability, total cost of ownership (energy cost), overall impact on the environment, and also anticipating future...

02-28

AGMA 6114-A06-2006 pdf download

Consensus is established when, in the judgment ofthe ANSI Board ofStandards Review, substantial agreement has been reached by directly and materially affected interests. Substantial agreementmeans much more than asimple majority, butnotnecessarilyuna- nimity. Consensus requires that all views...

02-27

AGMA 2116-A05-2005 pdf download

Between 1994 and 1998, AGMA published three standards on calibration of gear measuringinstruments:ANSI/AGMA2010--A94,MeasuringInstrumentCalibration–PartI, Involute Measurement, ANSI/AGMA 2113--A97, Measuring Instrument Calibration, Gear Tooth Alignment Measurement, and ANSI/AGMA 2114--A98, Measuring Instrument Calibration, Gear Pitch and Runout Measurements. These standards...

02-27