Free Standards Download

ASME A112.18.2:2005 pdf download Plumbing waste fittings 1 Scope 1.1This Standard covers plumbing waste fittings of sizes NPS-2 and smaller. 1.2 Plumbing supply fittings are covered by ASME A112.18.1/CSA B125.1 1.3 Other devices, e.g., temperature-actuated in-line mixing...

ASME A112.18.6:2003 pdf download FLEXIBLE WATER CONNECTORS 3.2.2 Organic Coatings (Exposed Surfaces). Organiccoatings on fittings of all substrates shall be testedaccording to all of the test procedures outlined below.(a) Corrosion. Corrosion tests for organic coating onmetal substrates...

ASME A112.19.2:2003 pdf download Vitreous China Plumbing Fixtures and Hydraulic Requirements for Water Closets and Urinals 2.7.3 Insulated Tanks Tanks that do not exhibit con-densation when tested in accordance with para, 7.6 shallbe considered as insulated. 2.8...

ASME A112.19.5:2005 pdf download Trim for Water-Closet Bowls, Tanks, and Urinals GENERAL 1.1 Scope This Standard establishes criteria for those items oftrim for water-closet bowls, tanks, and urinals knownas spuds, locknuts for spuds,flush valves, and flushelbows. Requirements...

ASME A112.19.1:2003 pdf download DUAL FLUSH DEVICES FOR WATER GLOSETS GENERAL 1.1 Scope This Standard covers physical and performancerequirements and test methods pertaining to dual flushdevices that are installed within water closet tanks whichuse 3.5 gpf (13.2...

ASME A112.20.1:2004 pdf download Qualification of Installers of High Purity Piping Systems 1.4 Examiners of High Purity Piping System WeldingNonmandatory Appendix A provides suggestedguidelines for examiners of high purity piping systemwelding 2GENERAL KNOWLEDGE 2.1 Terms and Definitions...

ASME A112-19-10:2003 pdf download DUALFLUSH DEVICES FOR WATERCLOSETS GENERAL1 1.1 Scope This Standard covers physical and performancerequirements and test methods pertaining to dual flushdevices that are installed within water closet tanks whichuse 3.5 gpf (13.2 Lpf) or...

ASME AG-1:2003 pdf download ARTICLE AA-D-3000 RECTANGULAR DUCTWORK AA-D-3100INTRODUCTION The methods presented in this article are suggestedmeans of approach for analysis of rectangular ductwork.The presence of compressive loads due to pressureor external forces requires that the ductwork...

ASME B1.1:2003 pdf download Unified Inch Screw Threads (UN and UNR Thread Form) GENERAL 1.1 Scope This Standard specifies the thread form, series, classallowance, tolerance, and designation for unified screwthreads.(In order to emphasize that unified screwthreads are...

ASME B1.10M:2004 pdf download UNIFIED MINIATURE SIREW THREADS 1.1 Scope This Standard specifies the thread form, series, toler.ance, and designation for the Unified Miniature ScrewThreads The series covers a diameter range of 0.30 mmto 140 mm, extending...