EN 13473-2-2001 pdf download.Reinforcement – Specifications for multi-axial multi-ply fabrics – Part 2: Methods of test and general requirements.
This Part 2 of EN 13473 defines the test methods to be used to determine the designated and specified properties given in Parts 1 and 3 respectively.
Part 2 of EN 13473 defines the general requirements app4icable to the specification of all types of multi-axial multipty fabrics falling within the scope of this specification as defined in Part 1 of this standard.
2 Normative references
This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies (including amendments).
EN 13473-1, Reinforcement – Specifications for multi-axial multi-ply fabrics – Part 1: Designation
EN ISO 527-4, Plastics — Determination of tensile properties — Part 4: Test conditions for iso-tropic and orthotropac
fibre-reinforced plastic composites (ISO 527-4:1997)
EN ISO 3344, Reinforcement products — Determination of moisture content (ISO 3344:1997)
EN ISO 10548, Carbon fibre — Determination of size content(ISO 10548:1994)
ISO 472, Plastics — Vocabulary
ISO 1887, Textile glass – Determination of combustible-matter content
ISO 1888, Textile glass – Staple fibres or filaments – Determination of average diameter
ISO 3374, Reinforcement products – Mats and fabrics – Determination of mass per unit area
ISO 4603. Textile glass – Woven fabrics – Determination of thickness
ISO 5025, Reinforcement products – Woven fabrics – Determination of width and length
ISO 11567. Carbon fibre – Determination of filament diameter and cross-sectional area
3 Terms and definitions
For the purposes of this European Standard, the following definitions given in ISO 472 and EN 13473-1 apply.
5 General requirements
5.1 Appearance
The mu’ti-axial multi-ply reinforcement taoric have to oe suosiantiaiiy iree irom contamination je. g. oii. den. eTc.) and shall not contain unacceptable levels of other faults (see Table 2 below).
On the basis of the defect classification according to Table 2, the total number of defects by points shall not exceed 20 per 100 m2 with a maximum 013 major defects. Major detects shall be counted 2 points, minor detects 1 point. A maximum of 2 defect points shall be counted per square meter, even if several defects occur simuftaneously. If required the product specification shall define alternative acceptance levels.
5.2 Packaging
The packaging shall protect the product during handhng, storage and transportation.
5.3 Labelling
Each package shall be identitied with:
5.3i Designation code (see EN 13473-1).
5.3.2 Total mass per unit area including ply Construction and binding system.
5.3.3 Width.
5.3.4 Length.
5.3.5 Weight of multi-axial multi-ply fabric package (net).
5.3.6 Detect designation.
5.3.7 Any special handling/storage instructions.
5.3.8 Manufacturers production and traceability reference.EN 13473-2-2001 pdf download.
EN 13473-2-2001 pdf download
PS:Thank you for your support!
