ANSI INCITS 330-2000 pdf download Reduced Block Command Set (RBC)- Amendment l
Scope and purpose 1.1 Scope This standard defines a Reduced Block Command set for logical block devices. The Reduced Block Commands along with the required SPC-2 commands and their restrictions described in this standard, fully specify the complete command set for RBC logical block devices.
1.2 Purpose The purpose of this document is to provide a command set of reduced requirements and options from SCSI Block Commands (ANSI NCITS 306-1998) for block devices. The reduced command set is intended to more closely match the functionality required for simple block logical units. The specified commands place no restrictions on device performance. The initial focus of this command set was rigid disks and removable media devices attached to Serial Bus and utilizing SBP-2 (ANSI NCITS 325- 1998) for command and control.
2 Normative references The standards named in this clause contain provisions that through reference in this text, constitute provisions of this American National Standard. At the time of publication, the editions indicated were valid. All standards are subject to revision; parties to agreements based on this American National Standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below.
Copies of the fllowving documents may be obtained from ANSI:
Approved ANSI standards;
Approved and draft regional and international standards (ISO, IEC, CEN/CENELEC and ITUT); and
Approved foreign standards (including BIS, JIS and DIN).
For further information, contact the ANSI Customer Service Department by telephone at (212) 642-4900, by FAX at (212) 302-1286 or via the World Wide Web at htp://ww.ansi.org.
Additional contact information for document availability is provided below as needed.
2.1 Approved references
ANSI NCITS 306-1998, Information Technology – SCSI-3 Block Commands (SBC)
ANSI NCITS 325-1998, Information Technology – Serial Bus Protoco/ 2 (SBP-2)
ANSI/IEEE 1394-1995, High Performance Serial Bus
ISO/IEC 13213:1994, Control and Status Register (CSR) Architecture for Microcomputer Buses
NCITS 306-1998, SCSI-3 Block Commands (SBC)
NCITS 325-1998, Serial Bus Protocol 2 (SBP-2)
2.1.1 References under development
At the time of publication, the followving referenced standards were still under development.
ANSI INCITS 330-2000 pdf download
PS:Thank you for your support!
