IEEE C57.19.01-2000 pdf download IEEE Standard Performance Characteristics and Dimensions for Outdoor Apparatus Bushings
1.Scope
This standard covers electrical, dimensional, and related requirements for outdoor power apparatus bushingsthat have basic impulse insulation levels (BILs) of 200 kV and above. It provides specific values for dimen-sional and related requirements that are to be interpreted, measured, or tested in accordance with IEEE StdC57.19.00-1991. Bushings covered by this standard are intended for use as components of oil-filled trans-formers and reactors. For information on ratings not covered by this standard and for replacement bushingsfor oil circuit breakers. refer to IEEE Std C57.19.01-1991.
2.References
This standard shall be used in conjunction with the following publications. At the time of publication, theeditions indicated were valid. Parties involved in agreements based on this standard are encouraged to inves-tigate the possibility of applying the most recent editions of the reference standards available at the time ofagreement.
IEEE Std C57.12.00-1993, 1EEE Standard General Requirements for Liquid-Immersed Distribution, Power,and Regulating Transformers.
IEEE Std C57.12.90-1999, EEE Standard Test Code for Liquid-Immersed Distribution, Power, and Regu-lating Transformers.
IEEE Std C57.19.00-1991 (Reaff 1997), 1EEE Standard General Requirements and Test Procedure for Out-door Power Apparatus Bushings.
IEEE Std C57.19.100-1995 (Reaff 1997), EEE Guide for Application of Power Apparatus Bushings.
At the time of publication of this standard, there were no equivalent dimensional standards inEC 60137:1995-12, Standard for Insulating Bushings for Alternating Voltages Above 1000 V.-
3. General requirements
Refer to IEEE Std C57.19.00-1991 for general requirements, definitions, and methods of measurements or tests applying to detailed requirements given in Clause 4.
4. Detailed requirements
Outdoor apparatus bushings conforming to this standard shall meet the requirements of the following as applicable:
a) Electrical insulation characteristics of Table 1
b) Dimensions of Figure 1, Table 2, and Table 3
c) Cantilever test values of Table 4
d) Partial discharge limits of Table 5
e) Power factor and capacitance limits of Table 6
IEEE C57.19.01-2000 pdf download
PS:Thank you for your support!
