AIA/NAS 1719-2011 pdf download RIVET, BLIND, 1 00° REDUCED FLUSH HEAD, (NAS1 097 HEAD), MECHANICALLY LOCKED SPINDLE
PART NUMBER EXAMPLE:
NAS1 71 9KE4L4A = 7050 ALUMINUM ALLOY RIVET; Ø.1 25 WITH .1 72 TO .266 GRIP RANGE;
ANODIZED SLEEVE, WITH FORMING ANVIL
NAS1 71 9H4L6F = 201 4 ALUMINUM ALLOY RIVET; Ø.1 25 WITH .297 TO .391 GRIP RANGE;
CHEMICAL FILM ON SLEEVE, WITH FORMING ANVIL
NAS1 71 9C5L2P = A286 CRES RIVET; Ø.1 56 WITH .062 TO .1 41 GRIP
NAS1 71 9C5L6M = A286 CRES RIVET; Ø.1 56 WITH .297 TO .391 GRIP RANGE; PASSIVATED WITH MOLYKOTE 1 06 SPACE COMPATIBLE LUBE, WITH FORMING ANVIL
NOTES:
/1 / RIVET DIA “4”, “5”, “6” INACTIVE FOR NEW DESIGN AFTER 1 SEPT. 1 990. USE “4L”, “5L”, “6L”.
/2/ GOLD COLORED ANVIL IDENTIFIES NOMINAL SHANK DIA.
/3/ MAXIMUM HEAD DIAMETERS ARE THEORETICAL SHARP CORNERS AS MEASURED BY PROJECTION.
/4/ EXCEPT FOR MECHANICAL PROPERTIES.
(5) DIMENSIONS IN INCHES AND APPLY AFTER FINISH AND PRIOR TO THE APPLICATION OF LUBRICATION UNLESS OTHERWISE SPECIFIED.
(6) THIS STANDARD TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN.
(7) UNLESS OTHERWISE SPECIFIED, PART INVENTORY MANUFACTURED TO PREVIOUS REVISIONS OF THE APPLICABLE DRAWING OR SPECIFICATION MAY BE PROCURED AND USED UNTIL STOCK IS DEPLETED.
(8) REFERENCED DOCUMENTS SHALL BE THE ISSUE IN EFFECT ON DATE OF INVITATIONS FOR BID.
(9) DIMENSIONING AND TOLERANCING PER ANSI Y1 4.5M-1 982.
/1 0/ EXCEPT FOR GRIP DASH NUMBER “2”, ALL OTHER RIVETS MAY BE INSTALLED TO THE BOTTOM LIMIT OF THE NEXT LOWER GRIP.
/1 1 / .001 SHANK DIA INCREASE PERMISSIBLE WITHIN .1 00 INCH OF BASE OF HEAD.

Share on Facebook

Post on X

Follow us

Save